![The elder scrolls v skyrim pc manual pdf](https://knopkazmeya.com/19.jpg)
GTK renewal and radio timer seem to be doing strange things, so I keep those set to 0, which kind of negates the purpose. One thing to note, on the wireless security tab, the 3600 GTK renewal setting is problematic. Pay close attention to the two wikis on wireless settings, because the default settings, especially on 'basic' are junk. Jenkins' article, some things have changed since then, especially in regards to dnsmasq and dhcp server and dns settings, but that is something I had to tinker with until I found what works without hiccups. If you aren't using QoS, you can set the txqueue length for eth0 (and eth0 ONLY) on Setup->Networking->Port Setup to 5 to start, and play around with it to figure out what works best. This is all I have in startup script currently:Įcho 262144 > /proc/sys/net/core/rmem_maxĮcho 262144 > /proc/sys/net/core/wmem_maxĮcho 16384 > /proc/sys/net/ipv4/netfilter/ip_conntrack_maxĮcho 16384 > /sys/module/nf_conntrack/parameters/hashsizeįor line in `nvram show | grep =$ ` do var=$ nvram unset $var done & Are your speed tests over wired or wi-fi? Some good starting point information if you haven't already found and read it:Īs previously stated, there is some info in the last linked article that no longer apply as far as the startup script tweaks, because most of them are at or below the current defaults. I agree stock firmware is dated and would like to get this to work at least close to what I had I did not mess too much with QoS or other knobs. I need to catch up on my build thread report posts. Speeds went UP from previous build, and this one does have the 'undefined' for CAKE in QoS (which, I am not using QoS atm). advertised speeds here.ĮDIT: I just flashed 40559 build.
![e4200 dd wrt download speeds e4200 dd wrt download speeds](https://i.imgur.com/WciquVY.jpg)
I am currently on 40527, build and am still within the margin of error on my speed test vs. I haven't done speed tests on K2.6 past 35531. FWIW, a lot of the tweaks in Steve Jenkins' blog for the E4200 no longer apply, there are very few that are even applicable to the K3.x or K2.6 builds.
![e4200 dd wrt download speeds e4200 dd wrt download speeds](https://i.ytimg.com/vi/hoYuLpkqfLM/maxresdefault.jpg)
The stock firmware is rather dated and has a lot of security holes and lacks a lot of patches. I actually thought there was some slowdown due to DD-WRT here, but I tested FreshTomato and directly connected to the ISP hardware and there is no noticeable change. I would need some details about configuration, i.e.
![The elder scrolls v skyrim pc manual pdf](https://knopkazmeya.com/19.jpg)